Description

The AF06 Range is a highly compact and efficient, mains powered high voltage power supply. The primary application is for air or oil fume purification. It is also suitable for other general purpose application.

The AF06 has a precise, stable and adjustable output voltage and output current. It is safe and reliable, with a high tolerance to the noise generated by electrical discharges.

The power supplies are designed as single output by default. The dual output power supplies are also available when customer specified.

Input specifications

Input voltage	220VAC (200VAC – 240VAC)
Input current	Less than 6A

Output specifications

Output voltage range	10kV to 60kV
Power range	600W, 800W and 1000W
Output polarity	Positive or negative. Please specify when ordering.
Line regulation	Less than 0.5%
Load regulation	Less than 0.5%
Voltage ripple	Less than 1% at full load.
Temperature drift	300ppm/°C maximum when operating under 55°C.

Protection

Short circuit protection	In the event of an output short circuit, the output current will remain at the set value.
Over-current protection	In the event of an output over-current, the output current will remain at the set value.
Spark protection	When the power supply experiences a spark on the load, the output will be switched off momentarily. After which, it will be restored automatically.

Controls

The power supply can be controlled by connecting to 9 way D type female connector or a 10 way IDC connector at the rear.

Environmental Requirements

Operating temperature	-10°C to 50°C
Storage temperature	-20°C to 80°C

Mechanical Specifications

Voltage range	10-20kV	30-40kV	50-60kV
Width	160mm	180mm	180mm
Height	105mm	136mm	155mm
Depth	268mm	310mm	340mm
HV output connector	On one side of the power supply	Mounted on the back panel	Mounted on the back panel
Control interface connector	9 way D type female connector (Optional: 10 way IDC connector)
Power input connector	Standard 3 way PCB terminal socket & plug 7.62mm pitch.

Safety

This power supply contains hazardous voltages and stored energy. Contact with the output may result in fatal injury. It should only be used and maintained by trained personnel.

• The area where the power supply is to be used should be kept clean and dry.
• Keep a safe distance from the output connector and remove any item which may come in to contact with the output.
• Ensure that a secure connection is made between the Earth side of the load and the green and yellow Earth lead.